The CZ Kadet magazine seems to be a magazine-within-a-magazine set up. The exterior is about the same dimensions as the 9mm magazine, but the "interior magazine" holds ten .22 LR cartridges. These magazines are not inexpensive in the $35 to $40 price range, but they are well-made and in my admittedly limited experience, work reliably.
The Kadet "upper" has a fixed barrel unlike some other .22 conversion kits. The rear portion of the slide moves ala S&W's Model 41, which means that the rear sight does not move. Like the front sight, it remains stationary over the fixed barrel. Though not absolutely mandatory, a nice characteristic of this slide setup is that the adjustable rear sight holds its adjustments; once set, it doesn't move.
In my opinion, the rear sight is quite satisfactory on this conversion unit and has held zero since it was set years ago.
I have owned one of these in my life and have shot only two others so my "experience" with them is based only on a statistically invalid number of units. That said, not one was free of the ocassional failure to fire when first purchased back around 1996.
It seems that this was a "teething problem" with the Kadet, but one that was quickly remedied by the company and is no longer a concern today. I contacted CZ-USA concerning this problem and was sent the "chisel-point firing pin" (free) and installed it into my unit after removing the round-nose firing pin. (It is my understanding that for several years now, the chisel-point is the Kadet's standard firing pin.) Changing the firing pins solved the problem for me and the other two Kadet owners I had seen.
Here you can see the chisel-point firing pin. It is easy to install and is held in place with a firing pin retaining plate like the 1911, Hi Powers and Pre-B CZ-75 pistols. I've been using this one for well over 10 years now with no issues.
Since changing firing pins, failures-to-fire have become pretty limited but still occur now and again. It has not happened with other than "bargain" ammunition, a small price to pay in my view for an easy-to-install conversion unit that actually groups considerably better than I initially expected and consistently tighter than the 1911-style .22 conversion "Kimber Platinum" (Ciener-manufactured) I shoot now and then and is also MUCH easier to disassemble for routine cleaning.
My individual CZ Kadet feeds every single type of .22 LR round I have tried in it and works flawlessly with standard velocity ammunition. With "high-speed" or "hyper-velocity" loads, it will sometimes fail to complete eject the fired hull. I am told that this can be easily corrected by filing a very slight angle on the ejector. I have not done this as I use this one only for paper and have pretty much opted to stay with a particular standard velocity load that the gun just "likes".
In this time of ammunition shortages, it seemed that CZ owners might be interested in the Kadet conversion unit. (It does not require the Form 4473 as it is not considered a firearm. The Kadet complete pistol is simply the conversion unit with a frame definitely is a firearm and the attendant federal rules apply. The conversion unit can be delivered to your door with no federal "paperwork".
At this point I will simply say that the Kadet "shoots". Mine has grouped nicely with more expensive match-grade ammo right on down to the bargain "bulk" loads. Every gun is a law unto itself, but mine shoots nothing, not Lapua, Eley or Federal match any better than Remington's 38-gr. HP designated "Sub-Sonic". Certain of the match loads shoot as well but not one groups better than the Sub-Sonic. While this certainly doesn't mean that the same has to be the case with other Kadets, it might be worth remembering as a possible pet load with today's ammo prices should you opt to get a Kadet pistol or conversion unit.
I recently tried another (relatively) inexpensive load in my Kadet unit: Aguila 40-gr. "Match Pistol". It has less felt-recoil than the Sub-Sonic but functions fine and groups very, very nicely as well.
Each group consists of 10-shots fired slow-fire from a standing position and using a two-hand hold. Distance is only 10 yards. POA was the center of the black bullseye. At this distance, POA matches POI for the Aguila load as well as the Remington Sub-Sonic for which the Kadet is actually sighted in. The flyers did not occur on the first shot; they were my fault. Neither this conversion nor any I've heard of suffer from "First Round Flyer Syndrome", ie: the first hand-chambered round not having the same POI as subsequent ones. Seeing that the gun will reliably work with this Aguila load and group satisfactorily, I intend to get more of it as I can.
At 15 yards, this 10-shot group was fired the same way as those at 10 yards. Other than the two low hits (my fault), the group is impacting just above POA, the center of the bullseye.
At the same distance, the Sub-Sonics do strike just below the POA and as usual, group very nicely in this particular Kadet.
At 25 yards, the Sub-Sonics are dead-bang "on" for me from the CZ Kadet. The flyer is my fault and I knew it when I threw it.
The slide locks back after firing the last shot. On this Kadet, this has not been an issue with any rimfire ammunition that I've ever fired in it.
For anyone owning a CZ-75 (B or Pre-B) or CZ-85, I think that these are very well-made and accurate conversion units if you happen to be interested in one. I have not kept up with prices as I've owned this one since about '96, but specs and pertinent information can be found at:
http://www.czusa.com/products_handguns_cz_75conv.php" onclick="window.open(this.href);return false;
If you are interested in the complete pistol, look here:
http://www.czusa.com/product_detail.php?id=34" onclick="window.open(this.href);return false;
I use mine as a "fun gun" and one to review and reburn such things as sight picture and trigger control back into my brain. The .22's miniscule recoil allows one to really focus on basics in my opinion and at the same time not be "spoilt" with the superb trigger-pulls common to match-grade rimfire handguns such as S&W's excellent Model 41 or the older Hi-Standard competition guns. (Please understand that were I in formal competition with a rimfire pistol, it would be with a competition-grade target pistol. I am not. Most of my shooting is with service style handguns and I think that using the not-bad-but-not-match trigger pull on my CZ-75 has its own advantages. I can slap on the "9mm upper" and still experiece the very same trigger pull.
I do not believe that the little .22 rimfire offers enough recoil to be really meaningful as a round for "practical" defensive-style shooting where recoil-recovery for the quick-but-accurate repeat shot is practiced. Speaking only for myself, I still think that any basic practice is worthwhile and to me, this is both fun and less-costly! One might shoot a hundred rounds of rimfire and then fewer centerfire in these times when ammunition can be pretty scarce!
The frame on this CZ-75 was hard-chromed decades ago and this particular pistol has fired lots more rimfire ammunition than 9mm. The Kadet will hold up to lots of shooting in my experience.
Good shooting and best.
PS: This review was requested quite a while ago and I apologize for the long response time. Various issues really slowed up my being able to "get with the program" but I am trying my best to complete all promised reviews, etc ASAP and in the order received.
