Search found 8 matches

by dano111
Sat Oct 10, 2009 8:59 pm
Forum: General Gun, Shooting & Equipment Discussion
Topic: New Taurus PT709 9mm
Replies: 58
Views: 12944

Re: New Taurus PT709 9mm

YabuUS wrote:Just returned from a session at American Shooting Center. Shot 100 rds through the new Taurus PT709 Slim. The gun performed flawlessly. Can't say quite the same for my marksmanship, however. I tend to shoot low and left. The sights on the Slim are adjustable, but I didn't have the right tool with me. The gun was very controllable and the recoil was not uncomfortable. I did invest in a mag loader to save the strain on my thumb. Also bought a box of 20 Federal Hydra Shok 124gr JHP at Carter's Country on the way home. Box of 20 for $24.95. I'm very satisfied with the Slim.
YabuUS,
That is great to hear! I had very similar results!
Congrats!!!

Dano
by dano111
Mon Oct 05, 2009 5:33 pm
Forum: General Gun, Shooting & Equipment Discussion
Topic: New Taurus PT709 9mm
Replies: 58
Views: 12944

Re: New Taurus PT709 9mm

Does anyone know how to go about getting the 9 round magazine for the Taurus Slim?

I checked the Taurus site and it is not listed.

Let me know..
by dano111
Sun Oct 04, 2009 8:37 pm
Forum: General Gun, Shooting & Equipment Discussion
Topic: New Taurus PT709 9mm
Replies: 58
Views: 12944

Re: New Taurus PT709 9mm

bobbb wrote:I've been looking for holsters for the 709 and if you like hybrid IWBs go to the kholster.com website. They now make one for the 709..they are like the Crossbreed Supertuck but cheaper and with a lot more adjustment capability...

bobbb, thanks for the input. I will definitely check it out. I also found "the Insider" at http://www.desantisholster.com" onclick="window.open(this.href);return false; for $26.00.

thanks again,
by dano111
Sat Oct 03, 2009 10:57 pm
Forum: General Gun, Shooting & Equipment Discussion
Topic: New Taurus PT709 9mm
Replies: 58
Views: 12944

Re: New Taurus PT709 9mm

YabuUS wrote:
dano111 wrote:I just got home from the range and am very impressed with the Taurus Slim.


dano111, I was very happy to read your good range report on the new Taurus Slim. I should pick mine up one day next week. I hope I have the same experience as you did when I take mine to the range. I'm pretty sure I will. Despite some nay sayers, Taurus makes very good guns. I own three of them. ;-)
TabuUS,
Let me know how it goes...I am very excited about this gun, it is much better than I expected.
I would recommend checking the slide before shooting, mine had a lot of grease in there, much more than I expected. I have to think that would affect the slide function pretty quick once the powder residue starts mixing with that...just a hunch...

Dano..
by dano111
Sat Oct 03, 2009 9:54 pm
Forum: General Gun, Shooting & Equipment Discussion
Topic: New Taurus PT709 9mm
Replies: 58
Views: 12944

Re: New Taurus PT709 9mm

Hey Joe,
Thanks...it looks like we are in the same general area..I see you are in Arlington. I'm in Little Elm just west of Frisco.
This is a great forum.

Take care,
Dano
by dano111
Sat Oct 03, 2009 6:38 pm
Forum: General Gun, Shooting & Equipment Discussion
Topic: New Taurus PT709 9mm
Replies: 58
Views: 12944

Re: New Taurus PT709 9mm

I just got home from the range and am very impressed with the Taurus Slim.
My expectations on the drive to the range were not extremely high. I thought the Slim would have significant recoil and not be very accurate but I was wrong on both accounts.
I put about 125 rounds of 115 grain FMJ through it without any problems. I did thoroughly clean and lube the gun before going to the range as it was shipped with quite a bit of grease and I thought that would affect its performance. It performed flawlessly. I am ready to put another few hundreds rounds through it just to make sure.

The trigger is a bit different than what i am use to and it took a few rounds to figure it out. Basically, in SA mode the trigger travels about 3/4 of an inch but only about the last third of that has any resistance. Once you get to that last little bit you feel the resistance and then the firing pin releases. What I liked about the trigger was you only needed to let the trigger reset last little bit for your 2nd shot. You do not have to let the trigger travel back to its original position. Makes for quick follow up shots.

One suggestion to Taurus for improvement...change the color of the follower in the magazines from yellow to black. The reason being is that when you look to see how many rounds you have in the magazine it is difficult to tell the difference from the color of the brass and the follower and would be easy to think you have one more bullet than you actually do.

Here are couple of pictures. I really like this gun and am now looking for a good IWB holster for carry..
100_3796.jpg
100_3793.jpg
by dano111
Fri Oct 02, 2009 10:45 pm
Forum: General Gun, Shooting & Equipment Discussion
Topic: New Taurus PT709 9mm
Replies: 58
Views: 12944

Re: New Taurus PT709 9mm

Well I went by a local gun store "just" to look around. And they happen to have a Taurus Slim in SS. It felt so good in my hand that I decided to pull the trigger...pun intended.
I am very anxious to get it to the range tomorrow and see how it shoots. I will be looking for a IWB holster as I plan for this to be my carry gun. If any of you have suggestions on what brands/models of IWB holsters work well with the Slim, please let me know.
I will let you all know how the shooting goes tomorrow.

Dano..
by dano111
Wed Sep 30, 2009 9:36 pm
Forum: General Gun, Shooting & Equipment Discussion
Topic: New Taurus PT709 9mm
Replies: 58
Views: 12944

Re: New Taurus PT709 9mm

I'm thinking of getting the Slim. Does anyone have any input either good or bad?
I have heard nothing but good things so far..
please share your thoughts.

Dano

Return to “New Taurus PT709 9mm”