Thank you. I will do that first thing tomorrow.puma guy wrote: ↑Sun May 30, 2021 4:21 pmYou may just need to clean the yoke barrel, that term will make sense after you view the video. The cylinder yoke is easily removed. It's held in by one screw on the right side of the side plate just above the front of the trigger guard.. When that screw has been removed move the cylinder release forward and swing the cylinder out. While holding the cylinder in place remove the yoke by sliding it forward out of the frame until it clears the frame and then pull the yoke and cylinder away from the frame together. I am attaching the Youtube video below. The video is long, but the part of how to remove the yoke comes early i.e 10:57; the gunsmith deals with the yoke and cylinder assembly at 45:20. Hope this helps and maybe saves you some money.
Search found 5 matches
- Sun May 30, 2021 7:29 pm
- Forum: General Gun, Shooting & Equipment Discussion
- Topic: Gunsmith in DFW
- Replies: 10
- Views: 9195
Re: Gunsmith in DFW
- Sat May 29, 2021 2:02 pm
- Forum: General Gun, Shooting & Equipment Discussion
- Topic: Gunsmith in DFW
- Replies: 10
- Views: 9195
Re: Gunsmith in DFW
I don’t believe ammo related because when you “open” the cylinder it will not turn. I am not just talking about a closed cylinder.
I may be completely wrong, but I don’t see the ammo being an issue with the open cylinder not turning.
I may be completely wrong, but I don’t see the ammo being an issue with the open cylinder not turning.
- Sat May 29, 2021 12:06 pm
- Forum: General Gun, Shooting & Equipment Discussion
- Topic: Gunsmith in DFW
- Replies: 10
- Views: 9195
Re: Gunsmith in DFW
No they were Federal and Remington in the green and white box.
Would reloads keep the cylinder from turning even when open?
Would reloads keep the cylinder from turning even when open?
- Fri May 28, 2021 5:19 pm
- Forum: General Gun, Shooting & Equipment Discussion
- Topic: Gunsmith in DFW
- Replies: 10
- Views: 9195
Re: Gunsmith in DFW
I took my revolver to the range. I usually do not shoot 357 at the range as I use 38’s. Well I left my 38’s on the dresser and grab 357 hollow points. The range was out of 38’s. So I though I would would shoot about 12 rounds. After the first six the cylinder locked up pretty tight. I sprayed some Ballistol down into the cylinder and worked it in and it felt okay. I closed the cylinder and dry fired it for some it worked great.
The next two rounds it locked up again. I did the above and finished up 6 rounds without any issues. Just would like someone to check it out.
- Thu May 27, 2021 4:46 pm
- Forum: General Gun, Shooting & Equipment Discussion
- Topic: Gunsmith in DFW
- Replies: 10
- Views: 9195
Gunsmith in DFW
Does anyone know of a good gunsmith in the DFW area for revolvers. I would like to get my S&W Model 19 2.5” barrel revolver serviced. Having a few issues of concern.