Chas,
The last batch (in the picture above) was run maybe 45min to 50mins. I have the food dehydration type dryer for Brass. However, To get the SS pins out of the cases, I do use Lyman media separator and I spin the cases in both directions for few minutes. This way, SS pins are out, water is expelled out of the cases. I lay the cases down on old shower towel 30 minutes or so. Then, rubbing the cases with the towel and said cases are good to go on the press.
Also, if I need to clean the primer pocket.
1) SS Wet tumbling for 30 mins
2) Air Dry or Hot Air Dehydration.
3) Deprime and size, On AP with case feeder, 1-stage only. It goes very fast...
4) SS Wet tumbling for 30 mins
5) Air Dry or Hot Air Dehydration.
Result: As clean as new including the primer pockets.
I tried the oven drying method too. Pre-heat to 175F-180F, lay the cases on cooking sheet in the oven for 20min or so. Remove the cases from the oven. Let them cool and they are good to go too. Media Separator may cut the oven time by 50%.
That being said, my wife was like
![anamatedbannana :anamatedbanana](./images/smilies/anim_bannana.gif)