TexasCHLforum.com

If you couldn’t pull the bolt to the rear (basically no eject of the round), it sounds like you may not have sized that round properly, or your sizing die is out of spec. I’m assuming you do full length sizing…If not, I would suggest you start.

This is a rather odd failure to fire issue. Usually, the problem with failure to extract comes after the round goes boom.

I have seen cases where very dirty chambers can cause the problem, but in those cases the problem was more prevalent then yours seems to be…and again it was after the round went boom.

Stevie’s question about signs of siring pin impact on the primer is a good one…any chance you had looked?