Page 1 of 1
Need a little AR help! DFW
Posted: Sun Oct 04, 2015 9:30 pm
by killerquad
Anyone near Frisco that can help me torque a barrel nut on an AR? I don't have a vice so I cannot get enough torque. If you have the tools and are familiar with doing these and you wouldn't mind helping a fellow CHL holder please let me know! Thanks.
Re: Need a little AR help! DFW
Posted: Sun Oct 04, 2015 9:31 pm
by ScubaSigGuy
I have a vice, and a receiver block, but I have never done that before. Let me know if you need me to be your last resort. I'm sure that we could figure it out.
Re: Need a little AR help! DFW
Posted: Sun Oct 04, 2015 10:00 pm
by killerquad
Thank you sir! I have the receiver block as well but I need to order a new barrel wrench. I have one of the multi-tools for it but honestly they suck. I will let you know as soon as I get the new one. I have the torque wrench as well so it "should" only take 3-5 minutes on a solid vise. Are you still in the same part of town?
Re: Need a little AR help! DFW
Posted: Mon Oct 05, 2015 12:18 am
by dcphoto
I have everything you need, but I'm not near Frisco. If you're further south any time let me know and I'll get you taken care of. Takes 15 minutes to get it done.
Re: Need a little AR help! DFW
Posted: Thu Oct 08, 2015 1:14 am
by killerquad
Thank you gentlemen. I actually called up my local gun shop and they took care of it for me!
