Safe practices. Avoiding unintentional discharges.

Gun, shooting and equipment discussions unrelated to CHL issues

Moderator: carlson1


JJR1971
Junior Member
Posts in topic: 1
Posts: 15
Joined: Fri Aug 10, 2007 5:04 pm
Location: Sugar Land, TX

best practice for carrying DA revolver in glovebox?

#16

Post by JJR1971 »

What would be the best practice for carrying a loaded DA revolver in the glovebox of a car as an "anytime" gun...all cylinders loaded or empty one over the hammer, leaving one with only 4 shots total. I guess I'm paranoid about accidental discharge(s) from bumpy roads, etc, especially in construction areas (which are a perennial feature of Houston traffic).

Is this a valid concern or should I not worry so much?

cbr600

#17

Post by cbr600 »

You have to decide what you feel comfortable with. I wouldn't carry an old SAA with a round under the hammer, but I personally don't worry about modern DA revolvers. FWIW, I carried a 4" Taurus as a car gun for years.

frankie_the_yankee
Banned
Posts in topic: 1
Posts: 2173
Joined: Sat Apr 07, 2007 1:24 pm
Location: Smithville, TX

#18

Post by frankie_the_yankee »

I would say that modern DA revolvers with either transfer bar safeties (Colt, Ruger and some others) or rebounding hammer safeties (S&W and others) are perfectly safe with all chambers loaded.

It's as close to impossible as impossible gets for a gun with a transfer bar safety like my Ruger SP101 tp go off without pulling the trigger all the way back. When the transfer bar is retracted the firing pin is surrounded by steel and nothing can touch it.
Ahm jus' a Southern boy trapped in a Yankee's body
User avatar

seamusTX
Senior Member
Posts in topic: 1
Posts: 13551
Joined: Fri May 12, 2006 12:04 pm
Location: Galveston

Re: best practice for carrying DA revolver in glovebox?

#19

Post by seamusTX »

JJR1971 wrote:What would be the best practice for carrying a loaded DA revolver in the glovebox of a car as an "anytime" gun...all cylinders loaded
Six rounds, hammer down, in a holster.

- Jim

shootthesheet
Senior Member
Posts in topic: 1
Posts: 961
Joined: Wed Feb 01, 2006 3:58 pm

#20

Post by shootthesheet »

One thing I would add is to make time to handle the weapon properly. Don't do it when your rushed for time. Better to carry a dirty weapon than someone being harmed.

Another would be to limit distraction. Get away from people if necessary. Lock the door or go to the garage. Someone talking or kids being inquisitive is when I make mistakes.

Do what was suggested by the OP. I go through the steps. Unload the weapon. Is the weapon unloaded? Did you(I) unload the weapon? Then move on.

If I dry fire any weapon it is done with the assumption the gun will fire. So, it is done in a way that no person can be shot. At the range is the best way but some use a bucket of dirt from what I have read.

GO BEYOND WHAT SEEMS NECESSARY. BE OBSESSIVE, ALWAYS. INSIST OTHERS ARE THAT WAY WHEN YOU ARE AROUND. Gun shows, shops, friends houses, hunting, etc. . It is not socially acceptable behavior to insist others do things safely. It is however, the right thing to do.

That is my opinion. Stay safe.
Post Reply

Return to “General Gun, Shooting & Equipment Discussion”